58001D

It is a motorized decoiler (or idle on request) with the capacity of 10 tons. Complete with hydraulic power pack and independent electric plant. Hydraulic unit for the spindle regulation, an electric plant for the automatic / manual mode and for the speed regulation. Complete with loop, arm for the loop control, and spokes to maintain the strip in the correct position.

Hydraulic loading cradle for coils. It is used to load automatically the coil on the decoiler. It has a vertical movement through a hydraulic cylinder and a transversal motion for the transport on the unwinding axis with a gear motor command. This model has a capacity of 10 tons.

It is positioned in the initial part of the line and it is essential for the correct introduction of the sheet and to maintain the correct position during working. It is made up of a metal structure and adjustable guide rolls.

Roll forming line of high quality, productivity and flexibility. It is characterized by the rapid change of cassettes (it is possible to change the product in a few hours) and materials and finishing rigorously controlled to guarantee for the client more production and less maintenance. It could be completed with sheet lubrication plant, strip introducer and independent regulations for each forming station.

It is the final hydraulic cutting shear. This particular system is used mainly with the trapezoidal / corrugated sheets. It is made up of a welded structure on which the cutting press inclusive the dies is installed. The movement is through a hydraulic power pack.

It is a set of forming rolls, made of tempered and rectified steel to make the profile requested by the client. The series of rolls is characterized by high precision and durability. Their function is at the heart of the whole plant; for this reason PM follows with particular precision the whole development (the whole process of roll-making is executed internally).

Final bench used for the unloading and for the stacking of the finished piece. This special unloading bench is used mainly for trapezoidal / undulated sheet. Its structure allows the unloading of one piece on top of the other in order to have a lot ready for packing.

The whole electric installation is intended here. Electric cabinet, cable channels, control desk and software for the management of the line parameters, all according to the highest standards of quality and efficiency.

L'impianto idraulico è necessario nelle operazioni di taglio e nelle unità idrauliche di punzonatura o scantonatura. È composto dalla centralina (di potenza tale da soddisfare tutte le lavorazioni), dai collegamenti meccanici (tubature e valvole) e dal software di controllo e gestione.